Repair and finishing of exposed concrete parts
Hello! This is Tamura!
This time, we repaired the non-shrink mortar placement mark at the crown of levee of the wall.
↓ (Because the position of the bolt was wrong, the part where the non‐shrinkage mortar was placed after removal)
I would like to fix this.
↓ (Situation where bolts are installed at regular positions with chemical anchors)
This is also beautifully finished.
First, polishing the non‐shrinkage casting part with a Level Grinding Wheel # 36 ⇒ flatten it.trowel-coating a thin coat of Repair Resin over the entire surface.
* Point: Since it is not glossy, do not use repelling,Squeeze thinly to cover the whole with just the Repair Resin.
After it is completely dry, lightly rub it with Paper # 600 to blend it in.
All you have to do is spray the color-adjusted C Repair Color to add a pattern, but ...
The point here as well!
If you try to erase only the repaired part (narrow area), it will stand out on the contrary.
As with all color matching,Spray it a little wider to eliminate the border and blur it.
By doing this, you can erase the repaired part with a good feeling.
Finished status
12 places in total
Time required: Approximately 2 hours
What I bought this time and can be purchased at our shop
Repair Resin
C Repair Color
Tone Color(Black, Yellow, Red)
Rubber Bowl
Pattern Pad-------------------------------------------------- -------------------------------------------------- ----------------------
At a Concrete Repair Shop, We sell tools and materials that can be used for partial repair of concrete.
In addition, a simple concrete repair method that anyone can do is also open to the public!
Even in the video, we are opening useful information on site such as various repair methods related to concrete!
